Abstract of this task is completed graduate design of the three parts of a two-cavity injection mold design. According to the structure of plastic parts, technical requirements and the actual situation of production, and 3-D design software Pro / E for three of the injection mold design. The design of the three links of the process, the design of the three links of the injection mold structure, and through the cavity pressure and the clamping force, the choice of injection molding machine, given the relevant technical parameters. Use of Pro / E, respectively gating system, the type of select, design agencies Stripping introduced, cooling the structure design, etc. were introduced. To reduce die costs, increase productivity, for a national standard parts, the design of a standard parts, including: injection mold-standard mode; standards-guided, guided sets, and so on. The recommended size of the parts are optional recommended design, such as gate sets, and so on.

中文 » 英语 翻译全文

关键词:

注射模=Injection Mould

分型面=Sub-surface

排气结构=Exhaust structure

推出机构=Introduction agencies

本文地址： http://www.goggeous.com/20250108/1/1328058

文章来源：天狐定制

版权声明：除非特别标注，否则均为本站原创文章，转载时请以链接形式注明文章出处。